Calcium-based mineral solution

Vitii Calci increases the total hardness of water. Rainwater lowers the total hardness, while evaporation (sun and wind) will have the effect of concentrating it. Too low a value is detrimental to filtration. Regularly check the mineral balance of the water, especially after heavy rains and in times of drought. Correct if necessary. Due to its composition, Vitii Calci promotes the filtration and clarification of water

Manual :

1. Remove the tap from the “Bag-in-box” pocket through the pre-cut hole in the box. Remove the safety tab on the faucet.

2. Place the bag-in-box box on the shelf of the Vitii "automation" panel in the corresponding location. See color code.

3. Slide the faucet into the corresponding connector. Snap the connector back onto the faucet and make 1⁄2 turn (clockwise) with the screw located on the top of the connector to lock the connector onto the faucet.

4. Make sure that the 4 bag-in-boxes of your Vitii filtration are correctly positioned on the "Automation" panel.

Vitii Calci is to be used continuously with the Vitii filtration set. As soon as the filtration starts, when the water temperature exceeds 12°C (spring, new installation, etc.), and after having measured and possibly adjusted the water parameters (see procedure for starting a Vitii bio-mineral filtration). To be used exclusively with the entire range of Vitii biomineral filtration balancing products (Bacteri+ / pH-i / Carboni).

Start-up: Check and correct if necessary the mineral balance of the water before starting the “automation” module of your Vitii filtration.

Maintenance: automatic with Vitii filtration. 1 liter of Calci in 30m3 increases the overall mineral concentration by 10mg/litre.

Storage: Store at room temperature. The product can be kept for 24 months. After opening (commissioning), the product can be kept for 12 months. Store in its original packaging.